How-to-guides for installing car security

Security

         Index

• Introduction

• Mounting control module

• Mounting L.E.D

• Starter kill

• Power distribution

• Door pin switches

• Power door locks

• Auxiliary outputs

• Remote power window control

• Remote power sunroof control

• Remote dome light control

• Wiring park lights

• Mounting the siren

• Mounting the shock sensor

• Remote power trunk release

• Valet switch

• Relay configurations

• Final testing

Testing

If you have a timed dome light which is hooked up to an instant trigger or sensor input, make sure the dome light has been timed out and turned off before testing the system. Crime Stopper alarms must be programmed to delay until the light is out. When testing the doors, make sure to test all of the doors. Many manufactures use a key-sense wire on the driver’s dome light switch (your car will chime when you’ve left the key in the ignition). If the door alarm wire is tied into this key sensing wiring system your alarm will sound when the driver’s door is opened. Remember to test each door to make sure that the alarm sounds on all of the doors.