How-to-guides for installing car security

In most cases, you can tie into the pin switches that are already in the car. Look for the switches that turn on the dome light when you open doors. Tap into the wires leading away from the switches. They can be found throughout the vehicles wiring . 

Many vehicles will have multiple circuits on each to switch, sell you will want to tap into the vehicles dome light wire , not the actual switch wire. this means that the I restore switch will be on a different circuit than the passenger door switchs etc. you may add texture protection by placing hand switches on the trunk or hood, however the shock sensor to wilted Oakley cover these areas to as it will take some type of force or impact to enter these locations.

also most vehicles , the quipped with truck and switches and are built into the latching mechanical part of the trunk lock. in this case you can tap into the vehicles wiring for the trunk switch usually found under the dash to or at the BCM (body control module). placing a pan switch or mercury switch will add extra protection as some would be thieves gain access under the hood to disconnect siren, horn or even vehicles battery.

.