Mobile

  Information Labs

    

5
 
  Site map About Us Help Contact Us Resources  

 

 

 

 

 

How-to-guides for installing car security

|.

Installation help, for installing, wiring and troubleshooting car security systems.

 

Security

         Index

 

Introduction continued

 

As we discussed on page 1 it is important to properly prepare before starting on the installation of your remote entry or security system to provide the best  protection and performance.

 

Were just about ready to start.... so hold on tight!

 

 

 

 

Be prepared

 

Tips and tricks:

 

1. Remove the doom light fuse from the vehicles fuse box, as many vehicles will have several lights throughout the vehicle and can drain the battery if left on for an extended period of time

NOTE:

If you remove the doom light fuse remember (when testing) the remote entry or security system that you may loose power to another function of the remote entry or security system. So remember to replace the doom light fuss during testing of the system.

 

2. Roll down at least one window. When working on the door lock and unlock portion of the installation, it is easy to lock the keys in the vehicle during testing.

 

3. You should decide where you are going to place all "peripheral" components, such as the siren, flashing LED, shock sensor, pin switches, etc. We discuss the peripheral location for each component in the corresponding chapters in this lesson.

 

4. Be sure to have all parts needed to complete the install of the system before starting, as it will make it more tempting to take short cuts during the processes. The parts required are discussed in parts required for instillation.

 

 

 

 

 

 

 

 

Where do I start

 

1. Start by identifying where you will install the security systems brain or control module. This is the small box that all wires will terminate to and all alarm features are processed.

2. Determine weather you will use the siren or vehicles horn for your sounding device. and determine where you will install the siren if you decide to use a siren.

 

 

Run all wires to all sensors, pin switches, shock sensors, e.t.c.

Connect the park light wire from the security system brain to the park light activation wire. See: connecting the park light activation wire.

 

Determine the location and install the L.E.D alarm status indicator. See: Installing the L.E.D.

 

Locate and wire vehicle door lock circuit from the door lock wires to the security systems brain. See: Connecting

 

  1. Take your time and verify that each segment of the system works as intended before going forward.

  2. Don’t drive your vehicle until you’ve secured any loose wiring.

  3. Carefully inspect engine compartment and other places for any components or tool left behind. Leaving a tool under the hood  and closing it can can destroy a vehicles hood or force it out of alignment.

 

 

 

 

 

 

Continue to:

Mounting the control module

 

Google

 

Help About Us Site map Contact Us Link to us Links

Copyright © 2001 - 2012 Mobile Information Labs.com